Sitting through an entire game on a hard seat or bleacher can get uncomfortable, especially if your team is losing. This stadium cushion has a handle and Velcro closure so the cover can be washed. Whether you’re at a high school football game or a professional baseball game, get comfortable with a stadium cushion. It’s a winning gift for sports fans.
Want to get the printable PDF instructions?
Pre-wash your fabric, especially if it’s cotton or a cotton blend.
Cut 2 pieces of your main fabric for the top and bottom. Add an inch to the width and length of your cushion or foam dimensions. This cushion is 15 by 17 inches, so I’m cutting 2 pieces that are 16 by 18 inches.
Measure and cut a piece that is 4 by 10 inches for the handle.
I’m using a contrasting fabric for the sides.
Measure and cut 2 pieces that are the length and height of the cushion plus 1 inch. That’s 3 by 16 inches for me.
Measure and cut 3 pieces that are the width and height of the cushion plus 1 inch, which is 3 by 18 inches here.
Make a mark 4 and 3/4 inches in from each end of a 3 by 18 inch piece. Center the handle and line it up with one of the marks and pin.
Fold the bottom of one of the 3 by 18 inch pieces in half an inch and iron. Fold in another 1/2 inch and press again.
Place the Velcro on the wrong side an 1/8th of an inch from the edge and pin. Sew on the Velcro close to the edges.
Make another half inch double fold on the top edge of the final 3 by 18 inch piece.
For this piece, sew down the edge of the fold.
This time, sew the Velcro on the right side.
Sew around the entire piece with a 1/2 inch seam allowance.
Back stitch when you get to the corners, and start sewing again on the next side.
If you’re going to be washing the cover, you may want to serge or zig-zag stitch the edges, use fray check, or cut with pinking shears to help prevent frayed edges.
Planning to see your favorite baseball team soon? Check out our selection of cotton MLB fabric.